8-Port Serial Gpim Components; Table 53: 8-Port Serial Gpim Components - Juniper SRX Series Manual

SRX Series Services Gateways for the Branch Physical Interface Modules Reference

8-Port Serial GPIM Components

Related
Documentation
98
8-Port Serial GPIM Key Features on page 99
8-Port Serial GPIM LEDs on page 100
8-Port Serial GPIM Interface Cables on page 161
8-Port Serial GPIM Interface Specifications on page 26
8-Port Serial GPIM Basic Configuration on page 230
Table 53 on page 98 lists the components of the 8-Port Serial Gigabit-Backplane Physical
Interface Module (GPIM).

Table 53: 8-Port Serial GPIM Components

Component
ONLINE/OFFLINE button
Only the SRX650 Services
Gateway supports
hot-swappable functionality
for GPIMs. The SRX550
Services Gateway does not
support hot-swappable
functionality for GPIMs.
Connector
Captive screws
8-Port Serial GPIM Overview on page 97
8-Port Serial GPIM Hardware Specifications on page 99
8-Port Serial GPIM Key Features on page 99
8-Port Serial GPIM LEDs on page 100
8-Port Serial GPIM Interface Cables on page 161
8-Port Serial GPIM Interface Specifications on page 26
Location
Right side of the GPIM
Middle or right of the GPIM
One on each side of the GPIM
Copyright © 2015, Juniper Networks, Inc.
Description
Use the ONLINE/OFFLINE
button to gracefully shut down
the GPIM. Press down and hold
the button for 4 to 5 seconds
and then release. The GPIM
gracefully shuts down and
turns off the power supply
units (PSUs).
To power up the GPIM (if the
Services and Routing Engine is
off), press and hold the
ONLINE/OFFLINE button for 4
to 5 seconds.
Two dual stacked 136-pin
VHDCI connectors. Custom
cables are used to connect
from the VHDCI connectors to
the data terminal equipment
(DTE) or the data
circuit-terminating equipment
(DCE)
Use the captive screws to hold
the GPIM in place.