Dual Ct1/E1 Gpim Network Interface Specifications - Juniper SRX Series Manual

Related
Documentation

Dual CT1/E1 GPIM Network Interface Specifications

Copyright © 2015, Juniper Networks, Inc.
Table 20: 8-Port Serial GPIM Network Interface Specifications (continued)
Description
Modes
Synchronous Tx/Rx rate/port
Error counters
HDLC Features
Mode
PPP, Frame Relay, and Cisco-HDLC
protocols
Shared flag
Idle flag/fill (0x7e or all ones)
Counters
8-Port Serial GPIM Overview on page 97
8-Port Serial GPIM Hardware Specifications on page 99
8-Port Serial GPIM Components on page 98
8-Port Serial GPIM Key Features on page 99
8-Port Serial GPIM LEDs on page 100
8-Port Serial GPIM Interface Cables on page 161
8-Port Serial GPIM Basic Configuration on page 230
The Dual CT1/E1 Gigabit-Backplane Physical Interface Module (GPIM) provides the
network interface specifications specific to T1 or E1 modes, listed in
Chapter 2: Network Interface Specifications
Specification
data terminal equipment (DTE)
clear to send (CTS)
data carrier detect (DCD)
data set ready (DSR)
data circuit-terminating equipment (DCE)
request to send (RTS)
data terminal ready (DTR)
Up to 8 Mbps
rx_error_counts, tx_abort_counts, rx_giant_counts,
rx_runt_counts, and crc_err_counts
56K or 64K
Supported
Supported
Supported
Runts, giants, fcs error, abort error, and align error
Table 21 on page 28.
27