Yamaha TMAX XP530E-A 2017 Service Manual page 91

1. Stator coil coupler
2. Sidestand relay
3. Turn signal/hazard relay
4. Radiator fan motor relay
5. Seat heater relay (power) (for XP530D-A)
6. Seat heater relay (control) (for XP530D-A)
7. Windshield drive unit relay (down) (for
XP530D-A)
8. Windshield drive unit relay (up) (for XP530D-
A)
9. Tail/brake light lead (left)
10.Crankshaft position sensor coupler
11.Stator coil assembly lead
12.Rear frame
13.Wire harness
14.Plastic locking tie
15.Clamp
16.Mudguard assembly
17.Tail/brake light cover
A. Install the wire harness clamp within this
range.
B. Connect the rear turn signal light lead by
matching the colors of the coupler (left: black,
right: white).
Connect the license plate light lead (blue-
black). (Color does not matter.)
C. The order of arrangement of the lead does
not matter as long as it is installed within this
range.
D. Install the plastic locking tie within this range.
E. Install the wire harness clamp to the rounded
end of the rib.
F. Fasten the white tape section of the stator
coil assembly lead and wire harness with the
plastic locking tie. The end of the plastic lock-
ing tie should be cut facing the outside.
G. Fasten the tape portion of each lead with the
clamp.
White tape: Wire harness, seat heater lead
(for XP530D-A)
Yellow tape: Mudguard assembly lead
It should be okay as long as the clamp is
aligned roughly to the tape section of each
lead.
H. The end of the plastic locking tie should face
the inside without being cut.
I. Route the rear turn signal light lead (left/right)
and license plate light lead through the hole
in the tail/brake light cover.
J. Install the wire harness clamp into the hole in
the rear frame.
K. Adjust the stator coil assembly lead and wire
harness to the position of the wire harness
clamp and fasten them with the plastic lock-
ing tie.
2-44
CABLE ROUTING