Checking The Steering Head; Removing The Lower Bracket - Yamaha TMAX XP530E-A 2017 Service Manual

EAS30213

REMOVING THE LOWER BRACKET

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Upper ring nut
• Rubber washer
• Lower ring nut "1"
• Lower bracket
TIP
Remove the upper ring nut and lower ring nut
with the steering nut wrench "2".
EWA13730
WARNING
Securely support the lower bracket so that
there is no danger of it falling.
Steering nut wrench
90890-01403
Exhaust flange nut wrench
YU-A9472
EAS30214

CHECKING THE STEERING HEAD

1. Wash:
• Bearings
• Bearing races
Recommended cleaning solvent
Kerosene
2. Check:
• Bearings "1"
• Bearing races "2"
Damage/pitting  Replace.
3. Replace:
• Bearings
• Bearing races
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bearing races from the steering
head pipe "1" with a long rod "2" and hammer.
b. Remove the bearing race from the lower
bracket "3" with a floor chisel "4" and ham-
mer.
c. Install a new rubber seal and new bearing
races.
ECA14270
NOTICE
If the bearing race is not installed properly,
the steering head pipe could be damaged.
TIP
• Always replace the bearings and bearing races
as a set.
• Whenever the steering head is disassembled,
replace the dust seal.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4-98
STEERING HEAD