Yamaha TMAX XP530E-A 2017 Service Manual page 205

g
A. Left side
B. Right side
6. Install:
• Rear brake caliper
• Rear brake lock caliper
(temporarily)
7. Adjust:
• Drive belt tension
Refer to "DRIVE BELT TENSION" on page
3-21.
8. Tighten:
• Wheel axle nut
• Rear brake caliper bolts
• Rear brake lock caliper bolts
Rear wheel axle nut
160 N·m (16 kgf·m, 118 lb·ft)
Rear brake caliper bolt
27 N·m (2.7 kgf·m, 20 lb·ft)
Rear brake lock caliper bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
EWA13500
WARNING
Make sure the brake hose is routed properly.
TIP
When tightening the wheel axle nut, there
should be no clearance "a" between the adjust-
ing block "1" and adjusting bolt "2".
2
1
9. Install:
• Rear wheel sensor "1"
h
a
4-38
Rear wheel sensor bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
ECA21080
NOTICE
Make sure there are no foreign materials in
the rear wheel sensor rotor and rear wheel
sensor. Foreign materials cause damage to
the rear wheel sensor rotor and rear wheel
sensor.
TIP
When installing the rear wheel sensor, check the
rear wheel sensor lead for twists.
1
TIP
To route the rear wheel sensor lead, refer to
"CABLE ROUTING" on page 2-31.
10.Measure:
• Distance "a"
(between the rear wheel sensor rotor "1" and
rear wheel sensor "2")
Out of specification  Check the wheel bear-
ing for looseness, and the rear wheel sensor
and sensor rotor installation conditions
(warpage caused by overtorque, wrong in-
stallation direction, rotor decentering, LOC-
TITE® on the mounting surface of the rotor,
deformation caused by an impact during ser-
vice and caught foreign materials). If there is
any defective part, repair or replace the de-
fective part.
Distance "a" (between the rear
wheel sensor rotor and rear wheel
sensor)
0.5–1.4 mm (0.02–0.06 in)
TIP
Measure the distance between the rear wheel
sensor rotor and rear wheel sensor in several
places in one rotation of the rear wheel. Do not
turn the rear wheel while the thickness gauge is
installed. This may damage the rear wheel sen-
REAR WHEEL