Fault code No.
Item
5
Defective throttle position sen-
sor (resistance).
6
Defective throttle position sen-
sor.
7
Malfunction in ECU.
8
Delete the fault code and check
that the engine trouble warning
light goes off.
P0122, P0123, P0222, P0223, P2135
[P0122] Throttle position sensor: ground short circuit detected.
[P0123] Throttle position sensor: open or power short circuit
detected.
[P0222] Throttle position sensor: ground short circuit detected.
[P0223] Throttle position sensor: open or power short circuit
detected.
[P2135] Throttle position sensor: output voltage deviation error.
Measure the throttle position
sensor resistance.
Refer to "CHECKING THE
THROTTLE POSITION SEN-
SOR" on page 8-246.
Check throttle position sensor
signal 1.
Execute the diagnostic mode.
(Code No. 01)
When the throttle valves are
fully closed:
A value of 11–20 is indicated.
When throttle valves are fully
open:
A value of 95–106 is indicated.
Check throttle position sensor
signal 2.
Execute the diagnostic mode.
(Code No. 13)
When the throttle valves are
fully closed:
A value of 8–22 is indicated.
When the throttle valves are
fully open:
A value of 92–108 is indicated.
An indicated value is out of the
specified range Replace the
throttle position sensor.
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-230.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
8-83
FUEL INJECTION SYSTEM
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" Go
to item 8 and finish the service.
Condition is "Detected" Go to
item 6.
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" Go
to item 8 and finish the service.
Condition is "Detected" Go to
item 7.
Service is finished.