EAS30581
CHECKING THE THROTTLE POSITION
SENSOR
1. Remove:
• Throttle position sensor
(from the throttle bodies)
EWA16690
WARNING
• Handle the throttle position sensor with
special care.
• Never subject the throttle position sensor
to strong shocks. If the throttle position
sensor is dropped, replace it.
2. Check:
• Throttle position sensor maximum resistance
Out of specification Replace the throttle
position sensor.
Resistance
1.20–2.80 k
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the digital circuit tester () to the
throttle position sensor terminals as shown.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
• Positive tester probe
Blue "1"
• Negative tester probe
Black/Blue "2"
2
B
b. Measure the throttle position sensor maxi-
mum resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
• Throttle position sensor
TIP
When installing the throttle position sensor, ad-
just its angle properly. Refer to "ADJUSTING
THE THROTTLE POSITION SENSOR" on page
1
B/L W
L
ELECTRICAL COMPONENTS
7-13.
EAS30582
CHECKING THE ACCELERATOR POSITION
SENSOR
1. Remove:
• Accelerator position sensor
(from the throttle bodies)
EWA16700
WARNING
• Handle the accelerator position sensor with
special care.
• Never subject the accelerator position sen-
sor to strong shocks. If the accelerator po-
sition sensor is dropped, replace it.
2. Check:
• Accelerator position sensor maximum resis-
tance
Out of specification Replace the accelera-
tor position sensor.
Resistance
1.08–2.52 k
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the digital circuit tester () to the ac-
celerator position sensor terminals as shown.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
• Positive tester probe
Blue "1"
• Negative tester probe
Black/Blue "2"
1
b. Measure the accelerator position sensor
maximum resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
• Accelerator position sensor
8-246
2
R L B/L W