Adjusting The Accelerator Position Sensor - Yamaha TMAX XP530E-A 2017 Service Manual

9. Install:
• Handlebar grip "1"
• Grip end "2"
Grip end
26 N·m (2.6 kgf·m, 19 lb·ft)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 1–3 mm (0.04–0.12 in) of clear-
ance "a" between the handlebar grip and the grip
end.
a
2 1
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
10.Adjust:
• Throttle grip free play
Refer to "CHECKING THE THROTTLE
GRIP" on page 3-33.
Throttle grip free play
1.0–3.0 mm (0.04–0.12 in)
11.Adjust:
• Rear brake lock cable length
Refer to "ADJUSTING THE REAR BRAKE
LOCK CABLE" on page 3-18.
EAS32442
ADJUSTING THE ACCELERATOR POSITION
SENSOR
EWA15960
WARNING
• Handle the accelerator position sensor with
special care.
• Never subject the accelerator position sen-
sor to strong shocks. If the accelerator po-
sition sensor is dropped, replace it.
1. Check:
• Accelerator position sensor
Refer to "DIAGNOSTIC CODE: SENSOR
OPERATION TABLE" on page 9-12.
2. Adjust:
• Accelerator position sensor angle
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Temporary tighten the accelerator position
sensor screws.
b. Check that the throttle valves are fully closed.
c. Connect the accelerator position sensor to
the wire harness.
d. Connect the throttle cables to the throttle ca-
ble pulley.
e. Remove the protective cap "1", and then con-
nect the Yamaha diagnostic tool to coupler.
TIP
For information about using the Yamaha diag-
nostic tool, refer to the operation manual that is
included with the tool.
f. Diagnostic code number "14" is selected.
g. Turn the throttle grip to the fully closed posi-
tion.
h. Adjust the position of the accelerator position
sensor angle so that 11–20 can appear in the
Yamaha diagnostic tool screen.
i. After adjusting the accelerator position sen-
sor angle, tighten the accelerator position
sensor screws "2".
Accelerator position sensor
screw
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
4-85
HANDLEBAR
1