Yamaha TMAX XP530E-A 2017 Service Manual page 115

1. Canister holder
2. Canister
3. Fuel tank breather hose (fuel tank to rollover
valve)
4. Rollover valve
5. Fuel tank
6. Fuel hose
7. Intake air pressure sensor
8. Thermostat cover
9. Clip
10.Canister purge hose (hose joint to canister)
11.Canister purge hose (throttle body to hose
joint)
A. Install the canister holder and canister with
the marks facing the top.
B. Install the fuel hose to the fuel rail so that the
paint mark on the fuel hose is facing upward.
C. The end of the clip should face the rear.
Place the clip at a distance of 3 mm (0.12 in)
or more from the hose end. Make sure the
clip does not ride on top of the bulge in the
hose mounting area.
D. Install the canister purge hose to the hose
joint with the longer side facing the rear and
the paint mark facing the right side.
E. The end of the clip should face the rear.
Place the clip at a distance of 2–4 mm (0.08–
0.16 in) from the hose end.
F. Install the canister purge hose with the end in
contact with the throttle body.
G. Fuel tank breather hose end portion
H. 90
I. Install the fuel tank breather hose with the
end portion is aligned within this range.
J. Install the intake air pressure sensor hose
with the intake air pressure sensor base unit
in contact with it.
K. 0–3 mm (0–0.12 in)
2-68
CABLE ROUTING