Checking The Abs Warning Light - Yamaha TMAX XP530E-A 2017 Service Manual

11.After the pulsating action has stopped in the
rear brake lever, it is generated in the front
brake lever and continues for a few seconds.
TIP
• The reaction-force pulsating action consists of
quick pulses.
• "ON" and "OFF" on the tool screen indicate
when the brakes are being applied and re-
leased respectively.
ECA22080
NOTICE
• Check that the pulse is felt in the front
brake lever, rear brake lever, and again in
the front brake lever, in this order.
• If the pulse is felt in the rear brake lever be-
fore it is felt in the front brake lever, check
that the brake hoses and brake pipes are
connected correctly to the hydraulic unit
assembly.
• If the pulse is hardly felt in either the front
brake lever or rear brake lever, check that
the brake hoses and brake pipes are con-
nected correctly to the hydraulic unit as-
sembly.
12.Push the OFF/LOCK switch.
13.Remove the Yamaha diagnostic tool from the
Yamaha diagnostic tool coupler, and then in-
stall the protective cap.
14.Push the ON/start switch.
15.Set the engine stop switch to " ".
16.Check for brake fluid leakage around the hy-
draulic unit.
Brake fluid leakage  Replace the hydraulic
unit, brake pipes, and related parts as a set.
17.If the operation of the hydraulic unit is normal,
delete all of the fault codes.
EAS30202

CHECKING THE ABS WARNING LIGHT

After all checks and servicing are completed, en-
sure that the ABS warning light goes off by walk-
ing the vehicle at a speed of faster than 7 km/h
(4.4 mi/h) or performing a trial run.
ABS (Anti-lock Brake System)
1
4-78