Yamaha TMAX XP530E-A 2017 Service Manual page 123

1. Radiator cap
2. Radiator filler hose
3. Coolant reservoir hose
4. Rear brake hose (hydraulic unit to rear brake
caliper)
5. Radiator bracket
6. Frame
7. Thermostat outlet hose
8. Thermostat
9. Coolant hose
10.Oil cooler inlet hose
11.Radiator outlet hose
12.Coolant reservoir
13.Canister purge hose (hose joint to canister)
14.Radiator
15.Rear brake lock cable
16.Cooling system air bleed hose
17.Clip
18.Clamp
19.Radiator filler pipe
A. Route the cooling system air bleed hose
between the rear brake hose and the rear
brake lock cable.
B. Route the cooling system air bleed hose
between the fuel tank bracket and the frame.
C. Install the cooling system air bleed hose with
the paint mark facing the top, and then put on
the thermostat cover.
D. Insert the coolant hose until it reaches the
rounded end of the pipe.
E. Install the clamp at a distance of at least 1
mm (0.04 in) or more from the hose end.
Make sure the hose clamp does not ride on
top of the bulge in the hose mounting area.
F. Install the clip with its end facing the left.
G. Insert the coolant reservoir hose until it
comes into contact with the rib of the radiator
filler pipe.
H. Insert the cooling system air bleed hose until
it comes into contact with the rib of the radia-
tor filler pipe.
I. Install the clamp with its end facing the right.
J. Make sure the clip does not ride on top of the
bulge in the hose mounting area.
K. 3 mm (0.12 in) or more
L. Install the clamp so that the paint mark on the
canister purge hose is visible.
M. Install the clamp by aligning it with the end of
the paint mark on the cooling system air
bleed hose.
2-76
CABLE ROUTING