Yamaha TMAX XP530E-A 2017 Service Manual page 101

1. Rear brake lock cable
2. Handlebar cover
3. Throttle cable (decelerator cable)
4. Throttle cable (accelerator cable)
5. Front brake hose (front brake master cylinder
to hydraulic unit)
6. Front brake master cylinder
7. Throttle grip
8. Handlebar switch (right)
9. Grip cancel switch lead
10.Handlebar switch (left)
11.Handlebar grip
12.Rear brake master cylinder
13.Rear brake hose (rear brake master cylinder
to hydraulic unit)
14.Brake hose holder
15.Rear brake lock lever
16.Grip cancel switch
17.Grip warmer lead
A. Route the rear brake lock cable through the
hole in the handlebar cover.
B. Route through the cable guide in the order of
the throttle cable (decelerator cable) followed
by throttle cable (accelerator cable).
C. Route the grip warmer lead, handlebar switch
lead (right), and front brake light switch lead
on top of and behind the handlebar.
D. Route the grip cancel switch lead between
the lower handlebar holder and the upper
bracket.
E. Route the grip warmer lead (left), handlebar
switch lead (left), and rear brake light switch
lead on top of and behind the handlebar.
F. Turn the rear brake lock lever up to the posi-
tion shown in the illustration before installing
the rear brake lock cable.
G. Install the grip warmer lead (left) into the slot
in the handlebar switch.
H. Case mating surface of the handlebar switch
I. 90±3
J. Install the grommet of the grip warmer lead
(right) into the slot in the handlebar switch,
and then hold and fasten it with the plate of
the throttle cable (accelerator cable).
K. Apply lithium-soap-based grease to the mov-
ing parts of the grip warmer lead (right) and
the inside of the handlebar switch (shaded
area in the illustration).
L. Fully open position
M. Fully closed position
N. The opening of the clamp should face the
front.
2-54
CABLE ROUTING