Replacing The Remote Control Unit, Steering Lock, And Ecu; Replacing The Remote Control Unit; Replacing The Steering Lock Unit; Replacing The Ecu - Yamaha TMAX XP530E-A 2017 Service Manual

7. Push the OFF/LOCK switch and Parking/Unlock switch simultaneously for 2 seconds. The use of
only the verified smart keys will be enabled. The use of all other smart keys will be disabled.
TIP
If the procedure was not completed successfully, repeat the procedure from step (1).
EAS32446

REPLACING THE REMOTE CONTROL UNIT, STEERING LOCK, AND ECU

TIP
The remote control unit, steering lock, and ECU cannot be replaced at the same time.
EAS32447

REPLACING THE REMOTE CONTROL UNIT

1. Replace the remote control unit, and then place only 1 previously used smart key within 80 cm (31.5
in) of the remote control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
4. Register any additional smart keys.
TIP
• If multiple smart keys were registered to the previous remote control unit, perform the preceding pro-
cedure for only 1 smart key. Do not perform the procedure for multiple smart keys at the same time.
• If the smart key identification number matches, it can be determined that the replacement procedure
is being performed for a legitimate user. Write the remote control unit identification number and smart
key identification number to the remote control unit and overwrite the smart identification number on
the smart key with the new number.
EAS31556

REPLACING THE STEERING LOCK UNIT

1. Replace the steering lock unit, and then place the previously used smart key within 80 cm (31.5 in)
of the remote control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
TIP
An identification number is not written to the steering lock unit when it is shipped from the factory. When
the vehicle system is turned on for the first time, the remote control unit identification number and smart
key identification number are automatically registered from the remote control unit to the steering lock
unit.
EAS31541

REPLACING THE ECU

1. Replace the ECU, and then place the previously used smart key within 80 cm (31.5 in) of the remote
control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
TIP
An identification number is not written to the ECU when it is shipped from the factory. When the vehicle
system is turned on for the first time, the remote control unit identification number is automatically writ-
ten from the remote control unit to the ECU.
SMART KEY SYSTEM
8-211