Yamaha TMAX XP530E-A 2017 Service Manual page 79

1. Handlebar switch coupler 1 (left) (black)
2. Front brake light switch coupler (black) (for
XP530D-A)
3. Rear brake light switch coupler (white) (for
XP530D-A)
4. Handlebar switch coupler 2 (right) (white)
5. Handlebar switch lead (left/right)/Grip warmer
lead (left/right) (for XP530D-A)/Front brake
light switch lead (for XP530D-A)/Rear brake
light switch lead (for XP530D-A)
6. Wire harness (accelerator position sensor
lead)
7. Positive battery lead
8. Headlight stay
9. Plastic locking tie
10.Wire harness
11.Handlebar switch coupler (right) (white)
12.Handlebar switch coupler (left) (white)
13.Electrical components tray
14.Handlebar switch lead (left/right)/Grip warmer
lead (left/right) (for XP530D-A)/Front brake
light switch lead (for XP530D-A)/Rear brake
light switch lead (for XP530D-A)
A. Arrange the front wheel sensor coupler in
front of the wire harness.
B. Lead going to meter assembly
C. To front wheel sensor
D. Handlebar switch coupler 1 (left) (black), han-
dlebar switch coupler 1 (right) (white), han-
dlebar switch coupler 2 (right) (white),
handlebar switch coupler 3 (left) (white), rear
brake light switch coupler (white) (for
XP530D-A), front brake light switch coupler
(black) (for XP530D-A), handlebar switch
coupler 3 (right) (black) (except for XP530D-
A), handlebar switch coupler 4 (left) (white)
(except for XP530D-A)
The order of arrangement of the coupler
above does not matter.
E. Route the end of the positive battery lead
(before the taped section at the bottom) so
that it does not go between the wire harness
and the headlight stay.
F. Install the clamp to the headlight stay.
G. Fasten the headlight stay and the white tape
section of the wire harness with the plastic
locking tie. The end of the plastic locking tie
should face upward without being cut.
H. Route the handlebar switch lead (left/right) on
the inside of the windshield drive unit cable.
I. Install the coupler to the electrical compo-
nents tray.
J. Pass the plastic locking tie through the hole
of the electrical components tray and fasten
the white tape section of the lead. The end of
the plastic locking tie should face downward
without being cut.
2-32
CABLE ROUTING