Rear brake lock caliper piston
locknut
22 N·m (2.2 kgf·m, 16 lb·ft)
Left-hand thread
6. Adjust:
• Piston adjusting bolt
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Tighten shaft L manually until it touches the
locknut.
b. With shaft L fastened, turn and adjust the pis-
ton adjusting bolt so that the length "a" be-
tween the end of shaft L and the end of the
piston adjusting bolt is changed to 19 mm
(0.75 in).
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
7. Install:
• Boot
• Rear brake lock caliper arm
TIP
• Check that the boot is installed correctly.
• Install rear brake lock caliper arm "1" in the po-
sition closest to cable holder "2".
8. Install:
• Rear brake lock adjusting nut
• Cap
Rear brake lock adjusting nut
15 N·m (1.5 kgf·m, 11 lb·ft)
9. Install:
• Rear brake lock pads
ECA22120
NOTICE
After installing the rear brake lock pad to the
caliper, check that the pad rotates smoothly.
EAS31422
INSTALLING THE REAR BRAKE LOCK
CALIPER
1. Install:
• Rear brake lock caliper "1"
• Rear brake lock caliper bolts "2"
• Rear brake lock spring "3"
• Pin "4"
• Rear brake lock cable adjusting nut "5"
Rear brake lock caliper bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
1
5
4
2
2. Adjust:
• Rear brake lock cable length
Refer to "ADJUSTING THE REAR BRAKE
LOCK CABLE" on page 3-18.
4-70
REAR BRAKE
3
2