Checking The Rear Brake Lock Pads; Checking The Wheels; Checking The Tires - Yamaha TMAX XP530E-A 2017 Service Manual

Rear brake lock adjusting nut
15 N·m (1.5 kgf·m, 11 lb·ft)
e. Make sure that the tire can be turned by hand
when the rear brake lock is deactivated.
f. Make sure that the wear indicator is placed
within the width of the wear indicator groove
when the rear brake lock is activated.
g. Install the cap of the rear brake lock adjusting
nut.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS31426
CHECKING THE REAR BRAKE LOCK
1. Check:
• Rear brake lock operation
Apply the rear brake lock, and then pushing
the vehicle for properly locks the rear brake
lock.
Rear brake lock not working properly 
Check the rear brake lock cable and rear
brake lock pads.
Refer to "ADJUSTING THE REAR BRAKE
LOCK CABLE" on page 3-18 and "CHECK-
ING THE REAR BRAKE LOCK PADS" on
page 3-19.
2. Check:
• Rear brake lock cable length
Out of specification  Adjust.
Refer to "ADJUSTING THE REAR BRAKE
LOCK CABLE" on page 3-18.
3. Check:
• Wear indicator "1"
Check the position of the indicator while ap-
plying the rear brake lock lever.
Passed the wear indicator groove "2"  Ad-
just the rear brake lock cable length.
Refer to "ADJUSTING THE REAR BRAKE
LOCK CABLE" on page 3-18.
2
4. Check:
• Rear brake lock caliper boot "3"
Cracks/damage  Replace.
Refer to "REAR BRAKE" on page 4-53.
1
3
PERIODIC MAINTENANCE
EAS31427

CHECKING THE REAR BRAKE LOCK PADS

The following procedure applies to all of the
brake pads.
1. Operate the rear brake lock.
2. Check:
• Rear brake lock pad
Wear indicators "1" almost touch the brake
disc  Replace the brake pads as a set.
Refer to "REPLACING THE REAR BRAKE
LOCK PADS" on page 4-67.
EAS31428

CHECKING THE WHEELS

The following procedure applies to both of the
wheels.
1. Check:
• Wheel
Damage/out-of-round  Replace.
EWA13260
WARNING
Never attempt to make any repairs to the
wheel.
TIP
After a tire or wheel has been changed or re-
placed, always balance the wheel.
EAS31429

CHECKING THE TIRES

The following procedure applies to both of the
tires.
1. Check:
• Tire pressure
Out of specification  Regulate.
3-19
1