Yamaha TMAX XP530E-A 2017 Service Manual page 81

1. Headlight control unit
2. Clamp
3. Front turn signal light coupler
4. Headlight assembly lead
5. Headlight sub-wire harness
A. Route the headlight sub-wire harness so that
the blue tape section is aligned with the rib
section of the headlight assembly.
B. Connect the headlight sub-wire harness cou-
pler to the coupler of the wire harness after
assembling the headlight assembly.
C. Fasten the headlight sub-wire harness and
headlight assembly lead with the clamp
between the right cover and the headlight
assembly mounting boss (within the range
shown in the illustration). The direction of the
clamp does not matter.
D. Route the headlight sub-wire harness (going
to the right turn signal light) in front of the
headlight assembly lead.
E. Fully push in the blue tape section of the
headlight sub-wire harness all the way to the
back of the rib section of the headlight
assembly.
F. Install the green tape section of the headlight
sub-wire harness to the rib section of the
headlight assembly.
G. Install the white tape section of the headlight
sub-wire harness to the rib section of the
headlight assembly.
H. Route the headlight sub-wire harness (going
to the left turn signal light) in front of the
headlight assembly lead. The number of
headlight assembly leads passing behind the
headlight sub-wire harness does not matter.
I. 3 locations
J. Push in the lead all the way to the back of the
rib.
K. The lead should enter on the inside of this
line.
L. Left and right 2 locations
2-34
CABLE ROUTING