Yamaha TMAX XP530E-A 2017 Service Manual page 204

Rear wheel pulley bolt
64 N·m (6.4 kgf·m, 47 lb·ft)
LOCTITE®
Drive belt guide bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
LOCTITE®
TIP
• Tighten the rear wheel pulley bolts in stages
and in a crisscross pattern.
• When tightening the drive belt guide bolts,
tighten the bolt at the punch mark "a" first and
then other bolts in stages and in a crisscross
pattern.
4. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
5. Install:
• Collars
• Rear wheel sensor housing
• Rear brake caliper bracket
• Rear wheel
• Adjusting blocks
• Rear wheel axle
• Washer
• Wheel axle nut
TIP
• Do not install the brake caliper and brake lock
caliper.
a
4-37
• Fit the brake torque stop pin "a" on the swing-
arm into the slot "b" on the rear brake caliper
bracket.
• When installing the rear brake caliper bracket
and the rear wheel sensor housing, align the
projection "c" on the rear brake caliper bracket
with the slot "d" of the rear wheel sensor hous-
ing.
• After installing the rear wheel to the vehicle,
make sure that the projection "e" on the brake
caliper bracket and the projection "f" on the
rear wheel sensor housing are aligned.
• Install the left adjusting block so that projection
"g" faces to the front of the vehicle.
• Install the right adjusting block so that upper
chamfer "h" faces to the top of the vehicle and
lower chamfer "h" faces to the bottom of the ve-
hicle.
b
e
f
REAR WHEEL
a
c
d