Yamaha TMAX XP530E-A 2017 Service Manual page 83

1. Storage compartment lid lock solenoid cou-
pler (except for XP530E-A)
2. Remote control unit lead
3. Grip warmer coupler (right) (gray)
4. Auxiliary DC jack coupler (black)
5. Grip warmer coupler (left) (black)
6. Windshield drive unit lead
7. Leg shield
8. Horn lead
9. Coolant pipe
10.Radiator fan motor lead
11.Throttle position sensor lead
12.Windshield drive unit cable
13.Wire harness (To handlebar switch)
14.Wire harness (To remote control unit)
15.Front brake light switch lead/Rear brake light
switch lead (for XP530D-A)
16.Grip warmer lead (for XP530D-A)
17.Plastic locking tie
18.Brake hose
19.Rear brake lock cable
A. Route the remote control unit lead on the
inside of the brake hose.
B. Route the brake hose on the outside of all the
leads.
C. Install the wire harness clamp into the hole in
the electrical components tray.
D. Route the auxiliary DC jack lead on the inside
of the brake hose.
E. Route the radiator fan motor lead on the
inside of the coolant pipe.
F. Fasten the radiator fan motor lead with the
clamp and install it into the hole in the radia-
tor bracket.
G. Route the wire harness on the inside of the
brake hose.
H. Install the radiator fan motor coupler (wire
harness side) into the hole in the stay.
I. Route the horn lead on the outside of the
brake hose and rear brake lock cable.
J. Install the wire harness clamp into the hole in
the stay.
K. Install the clamp of the steering lock unit lead
into the hole in the stay.
L. Route the rear brake lock cable between the
frame and the wire harness.
M. Route the rear brake lock cable between the
frame and the brake hose.
N. Route the rectifier/regulator lead between the
wire harness and the electrical components
tray.
O. Number of leads going to the handlebar
switch (XP530E-A/XP530-A: 6, XP530D-A:
4)
P. Do not fasten the bare wire and coupler
directly with the plastic locking tie. The end of
the plastic locking tie should face toward the
left from the front.
Q. Front of the vehicle
R. Range of arrangement of the end of the plas-
tic locking tie
S. Left side of the vehicle
T. Fasten the white tape section of the horn lead
and grommet of the brake hose with the plas-
tic locking tie. The end of the plastic locking
tie should face downward without being cut.
U. Install the wire harness clamp into the hole in
the front fuel tank bracket.
2-36
CABLE ROUTING