Yamaha TMAX XP530E-A 2017 Service Manual page 105

1. Headlight stay
2. Front brake hose (hydraulic unit to front brake
caliper)
3. Front brake hose (left brake caliper to right
brake caliper)
4. Clamp
5. Front wheel sensor lead
6. Front brake caliper (left)
7. Front wheel sensor
8. Front brake caliper (right)
9. Brake hose holder
10.Plastic locking tie
11.Stay
A. To hydraulic unit
B. 4.7–4.9 mm (0.185–0.193 in)
C. Fasten the white tape section of the front
wheel sensor lead and front brake hose with
the clamp. Install the clamp so that the front
wheel sensor lead is located on the right side.
D. Fasten the white tape section of the front
wheel sensor lead and front brake hose with
a clamp. Install the clamp so that the front
wheel sensor lead is located on the back.
E. Install the clamp into the hole in the brake
hose holder.
F. Route the front wheel sensor lead through
the brake hose holder.
G. Install the front brake hose with the paint
mark on the outside.
H. Install the brake hose holder with the rotation
stopper in contact with the headlight stay.
When using the dimension "B", it is not nec-
essary to let the stopper touch the headlight
stay.
I. Fasten the white tape section of the front
wheel sensor lead with the plastic locking tie.
The plastic locking tie should face downward
with the end cut to 5 mm (0.2 in) or less.
J. Install the stay with the identification mark
facing the front.
K. Install the front brake hose (left brake caliper
to right brake caliper) with the metal part in
contact with the positioning stopper of the
brake caliper. Install the front brake hose
(hydraulic unit to front brake caliper) by align-
ing the metal part to the direction of the metal
part of the front brake hose (left brake caliper
to right brake caliper).
L. Install the front brake hose (left brake caliper
to right brake caliper) with the metal part in
contact with the positioning stopper of the
brake caliper.
2-58
CABLE ROUTING