Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
Test harness S– pressure sensor
(3P)
90890-03207
Test harness S– pressure sensor
(3P)
YU-03207
• Positive tester probe
Pink/White (wire harness color)
• Negative tester probe
Black/Blue (wire harness color)
a
c. Push the ON/start switch.
d. Measure the intake air pressure sensor out-
put voltage.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30594
CHECKING THE INTAKE AIR
TEMPERATURE SENSOR
1. Remove:
• Intake air temperature sensor
(from the air filter case.)
EWA14110
WARNING
• Handle the intake air temperature sensor
with special care.
• Never subject the intake air temperature
sensor to strong shocks. If the intake air
temperature sensor is dropped, replace it.
2. Check:
• Intake air temperature sensor resistance
Out of specification Replace.
ELECTRICAL COMPONENTS
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the digital circuit tester () to the in-
take air temperature sensor terminal as
shown.
b. Immerse the intake air temperature sensor
"1" in a container filled with water "2".
TIP
Make sure that the intake air temperature sensor
terminals do not get wet.
1
c. Place a thermometer "3" in the water.
3
d. Heat the water or let it cool down to the spec-
ified temperatures.
e. Measure the intake air temperature sensor
resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
3. Install:
• Intake air temperature sensor
EAS30681
CHECKING THE FUEL INJECTOR
1. Check:
• Fuel injector resistance
Out of specification Replace the fuel injec-
tor.
8-249
Intake air temperature sensor re-
sistance
5400–6600 at 0 C (5400–6600
at 32 F)
Intake air temperature sensor re-
sistance
289–391 at 80 C (289–391 at
176 F)
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with tachom-
eter
YU-A1927
1
2
Intake air temperature sensor bolt
2.5 N·m (0.25 kgf·m, 1.8 lb·ft)