Yamaha TMAX XP530E-A 2017 Service Manual page 233

• First, tighten the upper bolt, then the lower bolt.
Angle "b" (brake master cylinder
and handlebar bracket)
120.1–122.7
2
2. Install:
• Brake hose gaskets "1"
• Rear brake hose "2"
• Brake hose union bolt "3"
Rear brake hose union bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
EWA13531
WARNING
Proper brake hose routing is essential to in-
sure safe vehicle operation.
ECA14160
NOTICE
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projection "a" as shown.
TIP
Turn the handlebar to the left and right to make
sure that the brake hose does not touch other
parts (e.g., wire harness, cables, leads). Correct
if necessary.
a
1
b
a
1 3
New
4-66
1
a
2
a
3. Fill:
• Brake master cylinder reservoir
(with the specified amount of the specified
brake fluid)
Specified brake fluid
DOT 4
EWA13540
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the boil-
ing point of the brake fluid and could cause
vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
4. Bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-17.
5. Check:
• Brake fluid level
Below the minimum level mark "a" Add the
specified brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-15.
REAR BRAKE
3