Fault Code No. P0560 - Yamaha TMAX XP530E-A 2017 Service Manual

Fault code No. P0560

Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Malfunction in charging system. Check the charging system.
2 Delete the fault code and check
that the engine trouble warning
light goes off.
Fault code No. P0601, P0606
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Malfunction in ECU.
P0560
Charging voltage is abnormal.
Able to start engine
Able to drive vehicle
—
—
—
Maintenance job
Refer to "CHARGING SYSTEM"
on page 8-19.
Defective rectifier/regulator or
AC magneto  Replace.
Defective connection in the
charging system circuit  Prop-
erly connect or replace the wire
harness.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
P0601, P0606
Internal malfunction in ECU. (When this malfunction is detected in
the ECU, the fault code number might not appear on the tool dis-
play.)
Able/Unable to start engine
Able/Unable to drive vehicle
—
—
—
Maintenance job
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-230.
8-93
FUEL INJECTION SYSTEM
Confirmation of service com-
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 2 and finish the service.
Condition is "Detected" 
Repeat item 1.
Confirmation of service com-
Push the ON/start switch.
Check that the engine trouble
warning light does not come on.
pletion
pletion