Estimated Traveling Range; Average Fuel Consumption - Yamaha TMAX XP530E-A 2017 Service Manual

When approximately 3.0 L (0.79 US gal, 0.66
Imp.gal) of fuel remains in the fuel tank, the last
segment of the fuel meter starts flashing. In ad-
dition, the information display will automatically
change to the fuel reserve tripmeter mode "F-
TRIP" and start counting the distance traveled
from that point.
In this case, push the select switch to switch the
display in the following order:
F-TRIP Display–1
play–3 F-TRIP
To reset a tripmeter, use the select switch to se-
lect the information display page that contains
the tripmeter you want to reset. Push the "
side of the select switch for one second so that
the tripmeter flashes, and then push the "
side of the select switch again for one second
while the tripmeter is flashing.
If you do not reset the fuel reserve tripmeter
manually, it will reset automatically after refuel-
ing and traveling 5 km (3 mi).
TIP
• The odometer will lock at 999999.
• The tripmeters will reset and continue counting
after 9999.9 is reached.
• Display cannot switch to setting mode display
when the "F-TRIP" indicated.

Estimated traveling range:

The estimated distance that can be traveled with
the remaining fuel under the current riding con-
ditions is shown.
Ambient temperature:
This display shows the ambient temperature
from –9 C to 50 C in 1 C increments. The tem-
perature displayed may vary from the actual am-
Display–2 Dis-
"
"
1-15
bient temperature.
TIP
• –9 C will be displayed even if the detected
temperature is lower.
• 50 C will be displayed even if the detected
temperature is higher.
• The accuracy of the temperature reading may
be affected when riding under 20 km/h (12
mi/h) or when stopped at traffic signals and rail-
road crossings.

Average fuel consumption:

The average fuel consumption mode "km/L",
"L/100km" or for the UK, "MPG" shows the aver-
age fuel consumption since the display was last
reset.
• "km/L" shows the average distance that can be
traveled on 1.0 L of fuel.
• "L/100km" shows the average amount of fuel
necessary to travel 100 km.
• For the UK: "MPG" shows the average dis-
tance that can be traveled on 1.0 Imp.gal of fu-
el.
To reset the average fuel consumption, use the
select switch to select the information display
page that contains the average fuel consump-
tion display. Push the "
switch so that the average fuel consumption dis-
play flashes, and then push the "
select switch again for 1 seconds while the dis-
play is flashing.
TIP
After resetting the average fuel consumption dis-
play, "– –.–" will be shown until the vehicle has
traveled 1 km (0.6 mi).
ECA25730
NOTICE
If there is a malfunction, "– –.–" will be con-
tinuously displayed. Check the vehicle.
FEATURES
" side of the select
" side of the