Checking The Wheel Bearings; Checking The Swingarm Operation; Checking The Drive Belt; Drive Belt Tension - Yamaha TMAX XP530E-A 2017 Service Manual

EAS30641

CHECKING THE WHEEL BEARINGS

The following procedure applies to all of the
wheel bearings.
1. Check:
• Wheel bearings
Refer to "FRONT WHEEL" on page 4-22 and
"REAR WHEEL" on page 4-31.
EAS30802

CHECKING THE SWINGARM OPERATION

1. Check:
• Swingarm operation
Swingarm not working properly  Check the
swingarm.
Refer to "REMOVING THE SWINGARM" on
page 4-108.
2. Check:
• Swingarm excessive play
Refer to "REMOVING THE SWINGARM" on
page 4-108.
EAS31431

CHECKING THE DRIVE BELT

1. Remove:
• Drive belt upper guard and lower guard
Refer to "REAR WHEEL" on page 4-31.
2. Check:
• Drive belt
External tooth cracks "A"  Replace.
Missing teeth "B"  Replace.
Hook wear "C"  Replace.
Stone damage "D"  Replace if damage is
on the edge.
Internal tooth cracks (hairline) "E"  OK to
run, but monitor condition.
Chipping (not serious) "F"  OK to run, but
monitor condition.
Fuzzy edge cord "G"  OK to run, but moni-
tor condition
Bevel wear (outboard edge only) "H"  OK to
run, but monitor condition.
Refer to "BELT DRIVE" on page 4-100.
PERIODIC MAINTENANCE
A
C
E
G
3. Install:
• Drive belt upper guard and lower guard
Refer to "REAR WHEEL" on page 4-31.
EAS32399

DRIVE BELT TENSION

Checking the drive belt tension
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
3-21
B
D
F
H