Duplex Reliability Configurations; High/Critical Reliability Configurations - Avaya S8700 Installing

Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
administrator. If the defaults are left administered this could create a serious security issue. For
example, the default Set community name string, with it's widely known value of Private, could
be used to shutdown power to the UPS loads via SNMP message.
7 When completed, disconnect the services laptop computer from the UPS.
8 Connect one end of a CAT5 cable to the RJ45 connector on the UPS 1 SNMP module
and the other end to the next available port on the Ethernet switch for Control Network A
(CNA).
Repeat steps 5 thru 7 for the UPS 2 SNMP module. Depending on the reliability
9
configuration to be installed use the following address, mask, and gateway information.

Duplex reliability configurations

For duplex reliability configurations use the following address and cable connection
information:
NOTE:
For duplex reliability configurations there are two servers and two UPS units. However,
there is only one control network. The following entries provide addresses on CNA for
UPS 2.
UPS IPaddress / Subnet mask = 198.152.255.238 / 255.255.255.0
•
• Default Gateway IP address = 198.152.254.202
• Host Table trap receiver IP address = 198.152.254.202
Local network administrator supplied information as required for Get and Set
•
community name strings.
Cable the RJ45 connector on the UPS 2 SNMP module to the next available port on the
•
Ethernet switch for Control Network A (CNA).

High/critical reliability configurations

For high and critical configurations use the following addresses and cable connection
information:
• UPS IPaddress / Subnet mask = 198.152.255.239 / 255.255.255.0
Default Gateway IP address = 198.152.255.202
•
Host Table trap receiver IP address = 198.152.255.202
•
• Local network administrator supplied information as required for Get and Set
community name strings.
• Cable the RJ45 connector on the UPS 2 SNMP module to the next available port on the
Ethernet switch for Control Network B (CNB).
Configure the SNMP Modules in the UPSs
May 2003
51