Test Terminating Trunk Transmission; Test Connectivity To The Lan - Avaya S8700 Installing

300 Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Testing the Complete Configuration
In some countries, this remote access interface is not allowed. Contact your Avaya
representative.

Test terminating trunk transmission

The Terminating Trunk Transmission Test provides for extension number access to 3 tone
sequences that can be used for trunk transmission testing from the distant end of the trunks.
1 Type change system-parameters maintenance and press
2 Under TERMINATING TRUNK TRANSMISSION TEST ( Extension ), type in 3
extension numbers in the 3 fields provided:
Test Type 100:_______Test Type 102:_______Test Type 105:_______
Test Type
Test type 100
Test Type
102
Test Type
105

Test connectivity to the LAN

To test the external IP connections for the C-LAN, IP Media Processor, and VAL circuit packs,
you must ping the circuit pack and ping a known computer connected to your network. If
everything is configured correctly, the Result column on the Ping Results screen reads PASS. If
it reads ABORT, verify the IP-address information and check the connectivity, including the
cabling.
Type ping ip-address IPaddress board UUCSS and press
1
The variable IPaddress is the IP address of the circuit pack and UUCSS is the cabinet,
carrier, and slot of the circuit pack.
Test Features
5.5 seconds of 1004 Hz tone at 0 dB
Quiet until disconnect; disconnect is forced after 1 minute
9 seconds of 1004 Hz tone at 0 dB
1 second of silence
Cycle is repeated until disconnect, which is forced after 24
hours
9 seconds of 1004 Hz tone at -16 dB
1 second of silence
9 seconds of 404 Hz tone at -16 dB
1 second of silence
9 seconds of 2804 Hz tone at -16 dB
30 seconds of silence
0.5 seconds of test progress tone (2225 Hz)
About 5 seconds of silence
Forced disconnect
May 2003
and go to screen 2.
Enter
Enter.