Upgrade Ipsi Firmware Version (If Necessary); Enable Control Of Ipsis - Avaya S8700 Installing

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway

Upgrade IPSI firmware version (if necessary)

You may need to upgrade the firmware on some or all the IPSIs. Each IPSI must be on the same
firmware load.
The following administration is done on a computer used to access the active media server
using the Maintenance Web Interface.
1 Under Installation and Upgrades click View IPSI Version. Select "Query All" and click
View IPSI Version.
2 Verify the firmware release for each TN2312AP IPSI. If an upgrade is required, follow
the procedures in the "Upgrading the Avaya S8700 Media Server Configurations,"
Upgrading IPSI Firmware, which is part of the Avaya™ S8300 and Avaya™ S8700
Media Server Library CD.

Enable control of IPSIs

NOTE:
Make sure the IPSIs have the same, current firmware.
NOTE:
This procedure enables the IPSI circuit packs and allows them to control the port
networks.
Type change system-parameters ipserver-interface and press
1
change system-parameters ipserver-interface
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix: vodka
Primary Control Subnet Address: 198.152.254.
Secondary Control Subnet Address: 198.152.255.
OPTIONS
IPSI Control of Port Networks: enabled
2 Set the IPSI Control of Port Networks: field to: enabled
Press to effect the change.
3
Enter
Switch Identifier: A
May 2003
Connecting to the IPSIs
.
Enter
Page 1 of
0
0
207
1