Avaya S8700 Installing page 120

120 Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Align the mounting holes in the rear ground plate over the bottom screws in the top
2
media gateway. See
View'' on page
3 Align the mounting holes in the ground plate with the four holes at the top of the media
gateway below the top media gateway. Slide the mounting plate down to seat on the
screws.
4 Check all Time Division Multiplexing (TDM) bus cables and the Inter- Cabinet Cables
(ICC) to be sure they are not pinched by the plates.
5 Repeat Steps 1-3 until the rear ground plates are installed between all stacked media
gateways.
Do not tighten the screws yet.
6
Rear Panel Screw Locations
Figure notes
1
2
''Rear Ground Plate and Front Plate or Media Gateway Clip — Side
121.
1
Expansion Control Media Gateway A (No ground
plate is installed on an un-stacked media gateway)
Rear Ground Plate (attached between stacked
media gateways)
4
2
May 2003
3
4
grnd_plt CJL 030696
Port Media Gateway B
3
4 Screws to Loosen