Install Earthquake Protection For Avaya Scc1 Media Gateway - Avaya S8700 Installing

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Perform this step first for all standard reliability media gateway stack installations.
1 Install the media gateway stack
Place expansion control media gateway A (J58890N) on the floor in the position
•
determined when the room layout was planned.
• Set port media gateway B (J58890H) on top of expansion control media gateway
A.
• Set port media gateway C (J58890H) on top of port media gateway B.
• Set port media gateway D (J58890H) on top of port media gateway C.
Install 2 through 44 media gateway stacks using the instructions in step 1.
2
Install Earthquake Protection for Avaya SCC1
Media Gateway
Earthquake protection installs only on Avaya SCC1 media gateways.
Position the expansion control media gateway A (J58890N) in the position it is to occupy
1
when the installation is complete. Be sure it is level.
Using a pencil or marker and using the Front Mounting Angle as a template, mark the
2
locations of the two floor mounting holes.
Move the media gateway out of the way and drill a hole 0.5-inch (1.3 cm) in diameter
3
and 1.5 inches (3.8 cm) deep at the locations marked in Step 2.
4 Insert a concrete floor anchor (STARR part number 3425) into each hole.
Secure the Front Mounting Angle to the floor using the short hex head bolts provided.
5
6 Move the media gateway back into place.
7 At the rear of the media gateway, remove the two hole plugs from the bottom of the
media gateway. See
102.
Insert a pencil or marker through the holes in the bottom of the media gateway and mark
8
the floor directly beneath each hole.
Move the media gateway out of the way and drill a hole 0.5-inch (1.27 cm) in diameter
9
and 1.5 inches (3.8 cm) deep at the locations marked in Step 10.
Insert a concrete floor anchor (STARR part number 3425) into each hole.
10
Move the media gateway back into place and align with the Front Mounting Angle.
11
12 Attach the media gateway to the Front Mounting Angle using the four supplied #12-24 x
1/2-inch (1.27 cm) thread-forming screws. See
page 103.
Lay the supplied Stiffener on the bottom rear of the media gateway and align with the
13
holes in the bottom of the media gateway. See
— Rear View'' on page
14 Slide a nylon washer onto each of the two supplied long hex head bolts.
''Media Gateway Earthquake Mounting — Rear View'' on page
102.
May 2003
''Front Mounting Angle Location'' on
''Media Gateway Earthquake Mounting
101