Installing The Stratum 3 Clock (If Used); Unpack And Inspect Stratum 3 Clock Cabinet; Install And Position Stratum 3 Clock Cabinet - Avaya S8700 Installing

Installing the Stratum 3 clock (if
used)
This section provides information on installing a Stratum 3 clock. The Stratum 3 Clock
connects to a TN2182C or higher tone-clock. In an S8700 Multi-Connect configuration, it must
connect to a tone-clock in a non-IPSI-controlled port network.
1 ''Unpack and Inspect Stratum 3 Clock Cabinet'' on page 177
''Install and Position Stratum 3 Clock Cabinet'' on page 177
2
3 ''Connect AC Power to Stratum 3 Clock Cabinet'' on page 178
''Check and Connect Commercial AC Power'' on page 178
4
''Connect DC Power and Ground to Stratum 3 Clock Cabinet'' on page 178
5
6 ''Connect Clock Cabinet Grounding'' on page 178
''Connect Stratum 3 Clock DC Power'' on page 178
7
''Set the Clock Options'' on page 179
8
9 ''Cable the Stratum 3 Clock'' on page 180
''Install the Stratum 3 Clock Wiring'' on page 182
10

Unpack and Inspect Stratum 3 Clock Cabinet

Check the status of the SHOCKWATCH and/or TILTWATCH indicators on the
1
cardboard container. If the container has been jarred or tilted beyond specifications, the
indicators are red, indicating possible damage.
2 Remove all packing material.
Remove front door and rear screw-on panels from the cabinet.
3
4 Inspect the cabinet for damage. Report any damage per local instructions.

Install and Position Stratum 3 Clock Cabinet

Check the location of the AC power receptacle. The receptacle must be on a separately fused
circuit that is not controlled by a wall switch. It must be located within 10 feet (3 meters) of the
cabinet and should be located outside the MDF area.
Position the clock cabinet in the designated location.
1
2 If earthquake protection is required, go
Gateway'' on page 70
Gateway'' on page 101
3 If earthquake protection is not required, level the cabinets and adjust and lock the cabinet
stabilizing bolts to keep the cabinet from moving.
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
or ''Install Earthquake Protection for Avaya SCC1 Media
May 2003

Installing the Stratum 3 clock (if used)

to''Install Earthquake Protection for Media
177