Ground And Connect Ac-Powered Media Gateways - Avaya S8700 Installing

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Expansion Control Media Gateway Battery Location — Right Side
1
2
Figure notes
Battery
1
2 Battery Lead Connector
Ground and Connect AC-Powered Media
Gateways
!
CAUTION:
S8700 Multi-Connect configuration grounding shall comply with the general rules for
grounding contained in Article 250 of the National Electrical Code (NEC), National Fire
Protection Agency (NFPA) 70, or the applicable code at the installation site.
NOTE:
Before connecting the media gateways to the approved ground, determine the best method
of grounding. See Approved Grounds
approved ground as close to the media gateways as possible.
NOTE:
The ground plates and media gateway clips are installed later in this procedure.
Connect the AC Grounds
''Connect AC-Power Ground'' on page 114
•
• ''Set the Ringer Frequency'' on page 115
''Connect the Power Cord into the Power Receptacle'' on page 116
•
Circuit Breakers (Located Between plates)
3
4 Media Gateway Single-Point Ground Block
for more information. Also, locate the
May 2003
3
4
4_3 LJK 031096
113