Avaya S8700 Installing page 63

Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Unpack the media gateways from the shipping material and inspect for damage.
1
2 Open and remove the front door and rear panels from the media gateway.
Verify the label near the circuit breaker on the power supply toward the rear of each
3
media gateway corresponds to the local voltage type.
!
DANGER:
If the label is different than the voltage type at the site, notify your Avaya
representative immediately for a replacement power supply. Do not, under any
circumstances, connect an incorrect power supply to a power source.
Unpack and Inspect the Media Gateways—G600
!
DANGER:
Use lifting precautions. An empty Avaya G600 Media Gateway weighs 35-39 pounds
(16-18 kilograms). Use caution to avoid injury.
1 Unpack the media gateway and remove all packing material.
Verify the equipment received. See
2
on page 64. Actual equipment may vary in appearance and may ship in separate
packages. Equipment comcodes are listed in
G600'' on page 65.
NOTE:
The Avaya G600 power cord, software and documentation CDs, wrist strap, mounting
screw kit, mounting template, and media gateway feet are shipped inside the media
gateway accessory compartment. See
on page 64.
The optional G600 media gateways for port hardware only are shipped with AC power
cord or international power cord kit, mounting screw kits, TDM/LAN bus cable, EMI
Gaskets, and two circuit pack slot labels. Install the label for the media gateway that works
with the Avaya S8700 Media Server (700207111) above the circuit packs. (This label has
an all-gray indicator for slot 1.) Discard the label for the media gateway that works with
the Avaya S8100 Media Server (700207806).
''Equipment packed with a single media gateway''
''Comcodes for equipment used with Avaya
''Equipment packed with a single media gateway''
May 2003
63