Connect Ac-Power Ground - Avaya S8700 Installing

114 Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway

Connect AC-Power Ground

1 Measure and cut a length of 6 AWG (#40) (4 mm
the media gateway stack single-point ground block and the approved ground. See
''Typical AC Power and Ground Layout — Rear'' on page
2 At the lower left rear of the expansion control media gateway A, connect the 6 AWG
(#40) (4 mm
3 Run the ground wire to the approved ground and attach securely.
Repeat Steps 1-3 for each expansion control media gateway A.
4
NOTE:
If the media gateway stacks are remotely located (in a separate room or building), run the
6 AWG (#40) (4 mm
At expansion control media gateway A, connect a 10 AWG (#25) (2.5 mm
5
single-point ground block. The 10 AWG (#25) (2.5 mm
reach the telecommunications cables at the rear of the media gateways, to follow these
cables to the Main Distribution Frame (MDF), and to terminate at the Coupled Bonding
Conductor (CBC).
The Coupled Bonding Conductor (CBC) wires are installed and terminated in
Coupled Bonding Conductor'' on page 167
2
) ground wire to the media gateway stack single-point ground block.
2
) media gateway ground wire to an approved protective ground.
May 2003
2
) wire long enough to reach between
115.
2
) wire must be long enough to
''Install the
2
) wire to the