Verifying That The Ipsis Are Translated; Upgrading The Ipsi Firmware Version (If Necessary); Enabling Control Of The Ipsis - Avaya S8700 Series Installing And Configuring

Hide thumbs Also See for S8700 Series:

Table of Contents

Chapter 6: IP interface configuration

Verifying that the IPSIs are translated

Note:

You must be on the active media server to use SAT commands.

Note:

1. Use SSH to open a SAT session on the media server.

2. Type list ipserver-interface and press Enter.

3. Verify that all ISPI circuit packs are translated.

You might need to upgrade the firmware on some or all the IPSIs. All IPSIs must have the same

firmware load.

1. On the Maintenance Web Interface under IPSI Firmware Upgrades, click IPSI Version.

2. Select Query All and click View.

3. Verify the firmware release for each IPSI.

4. If an upgrade is required, follow the procedures in Firmware Download Procedures at the

Download Center on the Avaya Support web site.

1. Ensure that the IPSIs have the same, current firmware.

2. For duplicated IPSIs, enable IPSI duplication before you enable IPSI control. See

IPSI duplication (duplicated control network only)

system-parameters ipserver-interface and press Enter.

3. Ensure the IPSI Control of Port Networks: field is set to enabled.

4. Submit the screen to save the changes.

Installing and Configuring the Avaya S8700-Series Media Server

on page 45. On the SAT, type change

Enabling

February 2007

Table of Contents