Hydraulic Valve Block Solenoid Coil Replacement; And #7 Reel On/Off Solenoid Coil Replacement - Toro Reelmaster 6500–D Service Manual

Hydraulic Valve Block Solenoid Coil Replacement

1. Remove solenoid coil:
A. Remove nut from solenoid.
B. Remove solenoid coil and o–ring at each end of
solenoid coil.
NOTE: There are two different solenoid coils used on
the hydraulic valve blocks. Cartridge valves VS1A and
VS1B use 28 Watt coils. All other valves use 20 Watt
coils. Make sure you use the correct replacement sole-
noid.
2. Install solenoid coil:
A. Make sure there is an o–ring installed at each
end of the coil.
B. Apply "Loctite 242" or equivalent to threads of
stem tube before installing nut.
C. Tighten nut to a torque of 15 in–lb. Over–tighten-
ing may damage the coil or cause the solenoid valve
to malfunction.

#6 and #7 Reel On/Off Solenoid Coil Replacement

1. Remove solenoid coil:
A. Disconnect the electrical connector
B. Remove the coil nut.
C. Remove coil assembly.
2. Install solenoid coil:
A. Install the new coil assembly.
B. Apply "Loctite 242" or equivalent to threads of
stem tube before installing nut.
C. Tighten nut to a torque of 15 in–lb. Over–tighten-
ing may damage the coil or cause the solenoid valve
to malfunction.
Electrical System
3
1 2
1. Adapter assembly
2. O–ring
3. Valve
4. Spool
Page 5 – 52
Figure 38
6
5
2
4
Figure 39
5. Tube assembly
6. Coil assembly
7. Coil nut
Reelmaster 6500–D/6700–D
7