Toro Reelmaster 6500–D Service Manual page 298

7. Mount the motor to the drive end of the cutting unit and
secure with two capscrews provided (Fig. 30).
8. On front center and left rear cutting units, plug speed
sensor wire harness connector into traction unit wire
harness connector.
9. On motor side of cutting unit, insert speed sensor end
of harness into frame tube and route to counterweight.
10. Install small O–ring onto speed sensor and insert
sensor into hole in counterweight.
11. Secure sensor to counterweight with a sensor holder
and a M6 x 20 mm capscrew.
12. Insert steering pin into either front or rear mounting
hole on pivot knuckle, using one of the following loca-
tions (Fig. 15):
Rear Mounting Hole–Keeps cutting unit in straight
line.
Front Mounting Hole–Allows cutting unit to steer it-
self as traction unit turns.
13. Hook wire around bottom of pin.
Cutting Units
Model 03853
Model 03854
Model 03855
6
5
4
3
1. Bearing housing
2. O–ring–large
3. Counterweight
4. O–ring –small
Page 7 – 22 Rev. B
1
1
Figure 30
1. Motor
2. O–ring
7
1
2
Figure 31
5. Speed sensor
6. Speed sensor holder
7. Frame tube
Reelmaster 6500–D/6700–D