Toro Reelmaster 6500–D Service Manual page 268

11
1. Bearing
2. O–Ring
3. Shim
4. Sleeve
5. Bolt
Disassembling Axle Housing
1. Remove axle from machine before disassembling:
A. Jack up rear of machine and support from frame
with jack stands.
B. Remove wheels from axle.
C. Remove hydraulic motor. Do not disconnect hy-
draulic lines from motor.
D. Support axle with a jack, then remove axle pivot
pin to separate axle from frame.
E. Pull axle out from under machine and put on a
work bench.
F. Be sure to account for thrust washers between
axle pivot and frame.
2. Remove bolts (Fig. 22, Item 5) securing adapter to
axle housing and remove adapter.
Axles, Planetaries and Brakes
4
3
2
6. Oil Seal
7. Bushing
8. Washer
9. Locknut
10. O–Ring
9
8
7
10
6
1
2
Instal seal so garter spring
faces hydraulic motor
Figure 22
3. Separate axle housing by removing bolts.
4. Pull out differential shaft (Fig. 16, Item 14) from hous-
ing (B).
5. Remove differential gear assembly (Fig. 16, Items
3–11) from axle housing (A).
6. Pull out differential shaft from housing (A).
Disassembling Sleeve Assembly
1. Remove sleeve (Item 4) from adaptor case. Straight-
en tab washer (Fig. 22, Item 8) and use special tool
TOR4040 to remove sleeve (lock) nut (Item 9).
2. Use a press or tap lightly on shaft end to force pinion
shaft out of case.
3. Remove oil seal (Item 6) and bearings (Item 1 and 11)
as necessary.
Page 6 – 14 Rev. B
12
5
11. Bearing
12. Adapter
13. Nut
14. Stud Bolt
15. Washer
Reelmaster 6500–D/6700–D