Cutting Unit Selection - Toro Reelmaster 6500–D Service Manual

Cutting Unit Selection

The Controller must be programmed with the Blade con-
figuration (number of Blades) on the installed cutting
units in order for the ClipAce
ly. If the Blade configuration is not set, the cutting units
will not operate in the mow position.
IMPORTANT: Do not sit in the seat. Closed Seat Switch
will void this procedure!
1. Rotate ignition key to Off position.
2. Connect the Hand held Diagnostic Tool to the Con-
troller Loopback Connector (remove overlays).
3. Turn the Reel Control Switch to Enable position.
4. Move the Joystick to the Lower position and hold.
5. Turn ignition key to On position and continue to hold
the Joystick in the Lower position until the Reel Control
Lamp starts to flash (2 seconds).
6. Release the Joystick to the center position. Reel
Control Lamp will now be on steady.
Cutting Units Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
T
feature to operate proper-
Page 8.1 – 32
7. Toggle Diagnostic Tool to display Outputs.
8. Cycle the Joystick to the Lower position once for
each blade on the installed cutting units (e.g. 5 times for
5 blades, 8 times for 8 blades, etc..). Wait for Reel Con-
trol Lamp to come back on before each cycle. Hand
held Diagnostic Tool will display the number of times the
Joystick has been cycled.
9. Turn Reel Control Switch to the Disable position.
Reel Control Lamp will now flash the number of blades
the Controller has been programmed for, then go out.
The Hand held Tool will also display the Blade configura-
tion programmed.
10. Turn the key Off and disconnect Diagnostic Tool.
Reconnect Loopback Connector. Blade configuration
is now set.
Note: Skip step 8 when verifying Blade configuration in
the field.
Rev. C Reelmaster 6500–D/6700–D