Lower/Mow/Raise Switches (Joystick); Enable/Disable Switch - Toro Reelmaster 6500–D Service Manual

Lower–Mow/Raise Switches (Joystick)
Each switch is normally open and closes when the joys-
tick is moved.
Test each switch by disconnecting the wiring connector
from the switch and connecting a continuity tester
across the two terminals of the switch being tested.
Testing
With the engine turned off, move the joystick, then allow
it to return to neutral while watching the continuity tester.
There should be indications that the switch is opening
and closing. With the joystick in the neutral position
there should be no continuity across the terminals.
Enable/Disable Switch(es)
Test the Enable/Disable switch by disconnecting the
wires from the switch and connecting a continuity tester
across the terminals of the switch.
With the switch in the DISABLE position, the tester
should show no continuity. With the switch in the EN-
ABLE position, the tester should show continuity.
NOTE: The Reelmaster 6700–D has three (3) switches.
Electrical System
(Reelmaster 6500–D shown)
(Reelmaster 6500–D shown)
Page 5 – 38
Figure 21
1. Joystick with switches
1
Figure 22

1. Enable/Disable switch

Reelmaster 6500–D/6700–D
1