Greasing Bearings, Bushings and Pivot Points
Each cutting unit has (6) grease fittings (Fig. 32) that
must be lubricated regularly with No. 2 General Purpose
Lithium Base Grease.
The grease fitting locations and quantities are: reel
bearings (2) and front and rear rollers (2 ea.)
IMPORTANT: Lubricating cutting units immediately
after washing helps purge water out of bearings and
increases bearing life.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until pressure is felt against handle.
IMPORTANT: Do not apply too much pressure or
grease seals will be permanently damaged.
3. Wipe excess grease away.
Reelmaster 6500–D/6700–D
Page 7 – 23
Rev. B
Figure 32
Cutting Units
Model 03853
Model 03854
Model 03855