Toro Reelmaster 6500–D Service Manual page 330

Bedknife Screw Tool TOR510880
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar. Make sure bedbar
threads are clean and use new screws. Tighten screws
to a torque of 250 – 300 in.lb. (288 – 345 KgCm) starting
in the middle of the bedknife as shown in figure 5.
NOTE: Remove all rust, scale and corrosion from bed-
bar surface before installing bedknife.
DO NOT use and air impact wrench with this tool.
Reel Drive Shaft TOR4074
Use reel drive shaft for rotating cutting reel when
hydraulic motor is removed (backlapping or sharpen-
ing).
NOTE: This tool is included in Cutting Unit Tool Kit
TOR4070.
Cutting Unit Tool Kit TOR4070
This tool kit includes special tools required for rebuilding
the cutting unit and cutting unit drive motor on the
Reelmaster 6500–D and 6700–D.
TOR4064 Spanner Wrench
TOR4065 Inner Oil Seal Installer
TOR4066 Bearing Installer
TOR4067 Shaft Support Tool
TOR4068 Inner Seal Installer
TOR4869 Outer Seal Installer
TOR4071 Outer Oil Seal Installer
TOR4072 Reel Motor Shaft Seal Protector
TOR4073 Handle
TOR4074 Spline Insert Tool
Cutting Units Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
Page 8.1 – 4 Rev. C
Figure 5
Figure 6
Figure 7
Reelmaster 6500–D/6700–D