Speedometer Sensor Installation - Toro Reelmaster 6500–D Service Manual

Speedometer Sensor Installation

NOTE: It is recommended that this procedure be done
1
with the motor removed from the machine.
1. Thread locknut onto speed sensor to allow full expo-
sure of sensor threads.
2. Center a motor piston with the center of the sensor
port (see Sensor Port View below). NOTE: If the motor
is on the machine use a tool to feel when a motor piston
is in the center of the sensor port.
3. Lubricate O–ring on sensor.
4. Thread sensor into port until sensor contacts piston.
Motor output shaft must rotate freely 360_.
Figure 40
5. Turn sensor out (counter–clockwise) until sensor
1. Speedometer sensor
orientation grooves are at a right angle + 3_ to motor
centerline, then back out sensor one full turn or 360_.
Hold sensor at this position and tighten locknut to a
torque of 75 – 125 in–lb (8.5 – 14.1 Nm).
Figure 41
Reelmaster 6500–D/6700–D Electrical System
Page 5 – 53