Crankshaft Installation
1. Put thread lock Loctite on the oil gallery plugs and
install them in the cylinder block.
2. Install the grooved main bearing shells. (See Crank-
shaft in the Inspection and Specifications section for
main bearing shell thickness.)
3. Install the crankshaft.
4. Install the no. 3, 4 and 5 main bearing caps.
5. Install the two end float half-washers (Fig. 72, Item
1), with the anti-friction faces towards the crankshaft.
6. Install the no. 2 main bearing cap (Fig. 73, Item 2)
with its two end float half-washers, with the anti-friction
faces towards the crankshaft.
Reelmaster 6500-D/6700-D
Page 3 - 51
Figure 71
Figure 72
Figure 73
Engine