Toro Reelmaster 6500–D Service Manual page 183

39. Put the port manifold (three plates bonded togeth-
er), valve side up, in a clean surface. Install three 3/4 in.
springs into the spring pockets (Fig. 121).
40. Apply a few drops of oil to the valve plate. Align the
grooves on the side of the port manifold with the grooves
on the side of the isolation manifold and assemble the
port manifold with the springs toward the valve plate
(Fig. 122). Be careful not to pinch a spring during instal-
lation. The two alignment pins in the valve plate will en-
gage the holes in the port manifold. The pin on the hex
drive assembly must engage the center hole in the port
manifold.
41. Install a new o–ring on the plug. Insert the check ball
hole in the port cover. Be sure the ball is seated in the
bottom of the check ball hole. Turn the plug assembly
into the port cover until the ball is retained (Fig. 123).
Reelmaster 6500–D/6700–D
Page 4 – 95
Figure 121
Figure 122
Figure 123
Hydraulic System