Set-Up And Adjustments - Toro Reelmaster 6500–D Service Manual

Set–up and Adjustments
IMPORTANT: Toro strongly recommends the use of a
leveling plate when setting–up or adjusting any reel type
cutting unit. The leveling plate will help to ensure accu-
rate and consistent adjustments.
Note: Right and left ends of cutting unit is determined by
standing in the operator's position (Fig. 7).
After the cutting unit is unboxed, use the following proce-
dures to assure the cutting units are adjusted properly.
1. Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of reel shaft.
2. Insure that all nuts and bolts are securely fastened.
3. Make sure carrier frame suspension operates freely
and does not bInd when moved back and forth.
4. Adjust bedknife to reel.
5. Adjust and level front and rear rollers.
6. Set height–of–cut.
Reelmaster 6500–D/6700–D
RIGHT
Page 8 – 7
Rev. B
LEFT
Figure 7
Cutting Units
Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992