Toro Reelmaster 6500–D Service Manual page 359

Greasing Bearings, Bushings and Pivot Points
IMPORTANT: Lubricating cutting units immediately
after washing helps purge water out of bearings and
increases bearing life.
Each cutting unit has (7) grease fittings that must be lu-
bricated regularly with No. 2 General Purpose Lithium
Base Grease.
The lubrication points are front roller (2), rear roller (2),
reel bearing (2), and bedknife adjuster.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until pressure is felt against handle.
3. Wipe excess grease away.
Note: Apply grease to reel bearing cavities until a small
amount is evident at the inboard reel seal.
Reelmaster 6500–D/6700–D Page 8.1 – 33 Rev. C
(2)
Figure 52
Cutting Units
Model 03857, S/N 80302 & Up
Model 03858, S/N 81419 & Up
Model 03859, S/N 81993 & Up
(2)
(2)