Toro Reelmaster 6500–D Service Manual page 326

Greasing Bearings, Bushings and Pivot Points
IMPORTANT: Lubricating cutting units immediately
after washing helps purge water out of bearings and
increases bearing life.
Each cutting unit has (6) grease fittings (Fig. 34) that
must be lubricated regularly with No. 2 General Purpose
Lithium Base Grease.
The grease fitting locations shown in figure 34 are for
each side of cutting unit.
IMPORTANT: Lubricating cutting units immediately af-
ter washing helps purge water out of bearings and in-
creases bearing life.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until pressure is felt against handle.
3. Wipe excess grease away.
Note: Apply grease to reel bearing cavities until a small
amount is evident at the inboard reel seal.
Model 03857, S/N 80001–80301
Cutting Units
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Page 8 – 26 Rev. B
Figure 34
Reelmaster 6500–D/6700–D