Cutting Unit Attitude Adjustment - Toro Reelmaster 6500–D Service Manual

Cutting Unit Attitude Adjustment

The cutting unit attitude may be adjusted or verified
using a gauge bar, Toro part no. 98–1852. which has
two screws and three hole locations. The second screw
is used in the inner hole to set or verify cutting attitude.
Adjust as follows:
1. Set front screw height to final height–of–cut setting
(Fig. 18).
2. Set rear screw, distance "B", lower than front setting
(Fig. 18).
.20" (5.3mm)
.15" (3.8mm)
.09" (2.3mm)
.04" (1.0mm)
3. Place gauge bar across front and rear rollers. Front
screw head should fit snugly over edge of bedknife and
end of rear screw should contact bottom of bedknife
(Fig. 19 & 20). Front and rear rollers should contact
gauge bar. Verify attitude at each end.
Reelmaster 6500–D/6700–D
(2 Screw Gauge Bar)
8_
6_
4_
2_
Page 8 – 13
ADJUST FOR FINAL HOC SETTING
"B"
Figure 18
BEDKNIFE
Figure 19
Figure 20
Rev. B Model 03857, S/N 80001–80301
Model 03858, S/N 80001–81418
Model 03859, S/N 80001–81992
Cutting Units