Specifications - Toro Reelmaster 6500–D Service Manual

Specifications

REEL CONSTRUCTION: Fairway reels. All welded. 5
or 11 blades.
HEIGHT OF CUT RANGE:
5 Blade – 3/4" to 1–1/4"
7 Blade – 1/2" to 1–1/8"
11 Blade – 3/8" to 3/4"
REEL DIAMETER: 7 in.
POWER: Reel motors feature quick disconnect for re-
moval or installation onto cutting unit. Cutting units can
be driven from either end.
HEIGHT–OF–CUT &
Height–of–cut adjustment is made at the rear roller with
quick locating pin and/or threaded micro–adjustment.
Front roller position is adjustable to 3 locations to set cut-
ting unit attitude.
Cutting Units
Model 03853
Model 03854
Model 03855
ROLLER ADJUSTMENT:
Page 7 – 2
Figure 1
BEDKNIFE AND BEDBAR ADJUSTMENT: Single
point adjustment mechanism.
CLIP FREQUENCY: .375" – 1.25". Reel speed auto-
matically adjusts to maintain proper clip. Reel speed is
continuously calculated based on the current forward
speed and the pre–set reel type and height of cut.
ROLLERS:
Front rollers: 3" diameter Wiehle rollers. Replacement
3'' diameter full rollers, Part No. 93–3040, are available
for the front position.
Rear rollers: 2.5" diameter full rollers. All rollers use the
same heavy duty ball bearings with two conventional
single lip seals and a Toro labyrinth seal to provide four
sealing surfaces to protect the bearings.
ROLLER SCRAPER KITS:
Front Roller Scraper Kit, P/N 93–2967.
Rear Roller Scraper Kit, P/N 93–2962.
Rev. B Reelmaster 6500–D/6700–D